The customer needed a lift table that could be raised up and
tilted in order to receive thin sheets of cut foam from a slitter process and
automatically stack up to 60 inches high. The requirement for the process was that
the system needed to be automatic. Air Technical Industries was able to design a
table that would receive each sheet and lower automatically to be ready for the next sheet
to slide on.
Air Technical Industries supplied their customer with a 4,000
pound capacity Zero-Low Lift & Tilt Table. This unit was designed for
instances just like this one in which a work line needs an adjustable height platform that
can be lowered directly to the ground for easy loading and unlading with a standard pallet
truck.
Engineers at Air Technical Industries equipped the table with
an automatic height gauge. This gauge would "see" when a sheet was slid
onto the table and then lower the table slightly to get ready for the next sheet.
When the table was full, the process would stop, the table would lower flush to the
ground, and could then be unloaded.
Unloading is no problem because the Zero-Low Lift &
Tilt Table is designed with a lowered height of less than one inch and a beveled edge
for easy, roll-on loading.
In addition, the unit is powered by a 5HP, 3-phase, 480 volt
motor and the lifting motion of the Zero-Low Lift & Tilt Table is activat4d
by precision built hydraulic cylinders with chrome plated shafts for smooth
operation. This table is equipped with push button operation but is also available
in a foot pedal variety.
By helping to efficiently handle the sheets of foam in this
customer's plant with the Zero-Low Lift & Tilt Table, Air Technical
Industries shows again that with material handling equipment, productivity can always be
increased. Air Technical Industries' sales consultants are happy to listen to any
situation and to provide innovative solutions to individual customer needs.
For more information, please contact us.
